Unofficial video until the official action video is released. Our radiator skid plate is called "The GateKeeper" because it acts as a gate between the rocks and your radiator support bar/radiator. The skid plate is constructed from 1/4" x 4" plate which runs across from left to right and curves up and bolts to bumper plate with two 3/8" x 1" Grade-8 bolts on each side. The seven slot design is constructed from eight 1" x 1.20 DOM Tubes, welded from the bottom plate to the upper mounting plate and bolts to your winch mounting point. Heavy duty design built to take a beating against the rocks Available in two designs - with or without the seven slot bars Compatible with HK Offroad Bumpers Only. If you would like to modify it to mount to a different bumper, it can be done as long as your current bumper has a flat bottom plate - see photos Comes "Primered - Ready to Paint". Optional powder coating is available at extra charge. Grade-8 Serrated-Flang Nuts and Bolts Included Description Through testing and banging on a few rocks we came to learn that the radiator support bar on the WJ is made of bread. Literally, thin sheet metal which can be damaged by the slightest impact. We have redesigned our radiator skid plate a few times since our Overland Bumper release in December and have finally come to a design that is satisfactory and actually serves a purpose. With our bumpers providing the perfect approach angle and strong mounting points, which reach all the way back near the sway bar bolts, it was imperative the radiator skid plate served a purpose as equal to the bumper. The actual skid plate which covers the bottom of the radiator support bar is made of 1/4" steel plate by 4" wide. The plate bends around and up the radiator support bar to reach our bumper and it mounts to the bumper. This mounting supports the underside of the skid plate for impacts where the Jeep falls from an obstacle onto an object such as a rock. The front of the skid plate is supported by eight 1" bars x .120 walls. These bars follow the lines of the upper grill to form the Jeep Seven Slot Grill Design. The 1" bars are welded to a 1/4" x 1.5" steel plate which bolts to the existing winch mounting holes. If you are not a fan of the seven slot design, we have the optional "GateKeeper III" which does not have the 1" bars. The point of the radiator support skid plate is to provide a gate between your radiator and the rock. For this reason we have decided to call it "The GateKeeper". The GateKeeper weighs 28.4 pounds. The GateKeeper III weighs approx 20 pounds. Currently, The GateKeeper is only compatible with our bumper. We are working on which will mount to our winch mounts, although it will not be compatible with factory bumper fascias. If you are using our winch mount with out the bumper fascia, this is a great add on and a mighty important one.